Camera Hardware Installation

Camera Hardware and Software Installation

Moderator: support

Camera Hardware Installation

Postby support » Sat Feb 27, 2016 9:48 am

Hi there,
Do you know how to set up camera after unboxing package? Please read below instruction.

Connect Network and Power
Connect the camera to your router using the Ethernet cable.
Using the included power adaptor, plug one end into the camera power jack and plug the other end into a power outlet.

connect came to router.jpg

Note: The DHCP server and Upnp must be enabled on your router(which is default setting on most router) to assign a local IP address to the network camera. If needed, please refer to your router's user manual on how to enable DHCP server and Upnp.

IMPORTANT!

Please note that for initial setup, you need to connect the camera directly to your router with a network cable. You can NOT connect wirelessly to the camera without first setting it up via a network cable. After initial set up only the power cable is required for the Wi-Fi connection.
Working Time: 1:00am-10:00am GMT Monday-Friday (6:00pm-3:00am PST Sunday-Thursday)
E-mail: support@tenvis.com
Skype: tenviscs
User avatar
support
silver
 
Posts: 3201
Joined: Fri Jul 05, 2013 9:48 am

Return to Camera Installation